I successfully installed El Capitan and used Multibeast to install drivers and Clover EFI partition on my newly created hackintosh. My USB 3.0 ports work fine, however for some reason I cannot get my 2.0 ports working.
I've installed both 3rd Party USB 3.0 & 7/8/9 Series USB Support through multibeast to no avail.
I've then tried to make sense and apply what I learned from this guide to try and get them working. Removing the ports restriction didn't do anything, and when I tried to add the non-working ports manually to my DSDT file, but the EHC1/EHC2 & XHC1/XHC2 categories don't exist in the clean copy I exported from Clover. I'm assuming what I need is an edited DSDT file specific to my system, but I have no idea where to start in creating one (anyone out there good with that?).
I've also been reading that changing the model identifier in the Multibeast installation could help - but I can't seem to find one that has specifications that match my system (I'm currently using Macbook Pro9,2 and everything seems to work except USB 2.0 & Bluetooth)
Anyone got any advice on how to get these working?
Edit: Here is a link to my DSDT file, if anyone would be kind enough to see what's up!
My specs:
USB Ports: 15 total.
Rear: 4x 3.0, 7x 2.0 (five black & two red - what's the difference?)
Front: 4x 2.0 (black)
-ASUS Rampage Extreme IV Motherboard
- x79 Intel Core i7 3960X 6-Core CPU 3.30 GHz
-32 Gigs Mushkin Blackline RAM
-ASUS GTX680 Graphics (with Nvidia driver)
-1x 500GB HDD, 2x 250GB SSD (Windows 10 on one, OSX on the other)
OSX El Capitan 10.11.4
[link] [comments]
Post a Comment