Hi, I follow the way in the post for Hackintosh of AMD FX6300 but some issue remains

I found this post of "[AMD FX-6300] OSX Mavericks 10.9.1 Hackintosh Installation Successful! Fully operational! [Audio, Internet, GPU, iCloud, iMessage]".

I followed the steps in the post and successfully installed Mac 10.9.1 on my PC. My PC consists of AMD FX6300 + Sapphire HD7870 2G + Asus M5A97 R2.0 and I have many issues after installation.

The key steps include the replacement of mach_kernel. If I use the boot loader of Multibeast, I got boot panic just like the author talked about int the post of "[AMD FX-6300] OSX Mavericks 10.9.1 Hackintosh Installation Successful! Fully operational! [Audio, Internet, GPU, iCloud, iMessage]".

To figure out the boot panic I had deleted the kext files of AppleIntelCPUPowerManagement.kext and AppleIntelCPUPowerManagementClient.kext in the SLE.

But after the deletion of these two files, I found my USB3.0 port did not work any more. Note that my USB3.0 worked normally before the deletion of the two files.

Several days I cannot boot from my hard disk (80GB SATA), since every time I booted I would get an error like "boot0 GPT boot0 test boot0 test boot0 done_". So in these days I had to boot from my flash disk (the flash disk made by Unibeast to install the Mac). Finally I found a way to figure the boot0 error out. The method is in the post of "boot0: GPT, boot0: test, boot0:test, boot0:done - since migration assistant" at http://www.tonymacx86.com/general-help/96742-boot0-gpt-boot0-test-boot0-test-boot0-done-since-migration-assistant.html

However, although the boot0 error had been fixed, later I began to face the issue of boot panic, just as I said previously. Then, I deleted the two files of AppleIntelCPUPowerManagement.kext and AppleIntelCPUPowerManagementClient.kext in the SLE. This method worked.

But now, at last, the issue of USB3.0, as I said before, is present. Anyone know how to figure it out?

PS: USB2.0 ports work normally. Only the USB3.0 ports are down.

submitted by TomHsiung

[link] [comment]

What is missing? Please comment to help! ...[source] For more info try www.iatkos.net