Hi /r/hackintosh,
I have a Windows/OS X dual boot and am having trouble booting OS X from the SSD. When I boot from the Clover USB everything works perfectly fine, its very stable (only issue is no audio). When I try to boot from the SSD the Apple logo appears for a few seconds, then I get the loading bar and it is slower than usual. About 2/3 the way through it slows down and about 7/8 of the way it black screens for good. Also worth noting that the monitor loses video output after this black screen but the PC stays on (all fans running, LEDs on).
Here is a screenshot of the verbose just before it crashes. It also flashes another line shortly before it black screens and it is hard to catch on camera.
My drive config is an SSD with Windows installed, a data HDD (both drives NTFS) and a separate SSD for OS X.
My specs are an i5 4590, Gigabyte Z97-SLI and GTX 980 Ti. Full List.
What I have tried to fix this is copy the Clover folder from the EFI partition of the USB to the EFI partition of the SSD. I have also tried to manually install the NullCPUPower... and FakeSMC kexts by dragging them into the 10.11 kexts folder in the EFI partition but no luck.
I'm running 10.11.1 instead of 10.11.2 because I already had a Unibeast 10.11.1 USB created so I figured there was no reason to recreate it just for this.
I tried following step 5 on the tonymacx86 guide (multibeast setup) and that didn't work and messed up my motherboard so it would stick at the POST so I had to manually reset CMOS. After it booted again I tried step 6 (alternate installation with the clover configurator) and that didn't work.
I'm super stumped here guys, any direction would be greatly appreciated.
Also if there is an easy fix to the audio thing please let me know. My motherboard has ALC1150. It's not a huge priority as I can figure it out after I fix the boot.
[link] [comment]
Post a Comment