Install went fine
Dx58so board with dsdt bios 5600 Uefi boot W3680 hex core Gtx660
If I downgrade the bios to 5020 and load optimal defaults and upgrade back to 5600 sometimes clover sets the proper cpu multiplier or 25 and shows turbo boost capable in the boot log and will step from 12-25 and boost to 26 not seen 27 because that is rare single thread
In the boot log it should have turbo boost values for each of the six cores but it only has 4 probably a programming oversight. When it picks up the proper info it has 26/26/27/27.
Usually it does no pick it up. Boot log shows the correct processor name and I'd but says not turbo boost capable has 0/0/0//0 in the turbo variables and it will only step 12 and 25 no turbo boost.
Benches do vet out the performance is taking a hit so it's not cosmetic
Gen c states p states and allow c2 c4 are checked
Also I am using Mac Pro 5,1 definition and have ecc ram installed but it showes as disabled in about this Mac
If I run memtest from a flash drive ecc is working there
Some bizare behavior. Any help appreciated
[link] [comments]
Post a Comment