STEPS (assuming Windows 8.1 or below, I am not good at EFI troubleshooting, this is how I did it)
First: Prepare your USB by making the OS X installer and installing Clover (there are plenty of tutorials online)
Second: Boot the OS X installer and format your drive into two partitions with the GPT partition map.
Third: Format both partitions as HFS+
Fourth: Boot into your Windows installer
Fifth: Install windows on your desired partition.
Sixth: Boot Mac OS X installer and install!
THAT SHOULD BE IT for INSTALLATION
NOTE: Install Windows as UEFI if supported on your motherboard.
POST-INSTALL
You REALLY REALLY want to make sure you get Clover installed before anything so you have a base EFI setup.
Make sure you can boot into both partitions.
Inject all the necessary kexts
ENJOY!
[link] [comments]
Post a Comment